Plate heat exchanger is an important part of heat exchange technology in process industry equipment. The elastic gasket that seals between the various plate fins is a vulnerable part, and it is also a part that is prone to aging under natural conditions. Its service life has an important influence on the service life of the plate heat exchanger. If these seals are thermally hardened and lose their original elasticity, the heat exchanger may not work properly.
The following factors have an important influence on the service life of the elastic gasket: the working method of the heat exchanger (continuous or discontinuous), the corrosiveness of the heat dissipation medium and the cleaning agent used, the maximum working temperature, the maximum working pressure, and the Large pressure and unbalanced pressure make the stress of the elastic gasket larger and it will naturally age.
The softening of the elastic gasket is related to pressure and temperature. When the gasket loses its elasticity, the heat exchanger will leak. In some products, in order to solve the dripping phenomenon caused by the aging of the sealing gasket, it is allowed to adjust the sealing performance of the heat exchanger, that is, tighten the bolts of the combined plate heat exchanger again to adjust the elastic sealing gasket between each heat exchanger The pressing force can solve the dripping problem. Generally, the maximum and minimum allowable stress are given on the nameplate of the heat exchanger with this function. For new heat exchanger fins, the smallest allowable stress should be used for connection and fixation. Depending on the number of heat exchanger plates in each group, the tightening force of the heat exchanger can be adjusted one or more times. Each time the nut is tightened, the nut can be screwed into 3mm, and always pay attention to the stress of the adjusting plate during the tightening process, and , It is only allowed to adjust the tightening force of the heat exchanger without working pressure at room temperature to prevent dripping.